IBM Netfinity 5Ux24D Tower-to-Rack Kit, Installation Instructions Manual

Page: 28 / 38

Using the Netfinity 5600 setup utility diskette
If you are installing the 5Ux24D Tower-to-Rack Kit on a Netfinity 5600 server, insert the IBM Netfinity 5600
Hot-Plug SCSI Setup Utility disk in drive a: and restart the system.
Important
1. Only run this utility if you are installing this kit on a Netfinity 5600 server.
2. Failure to run this utility if you are installing this kit on a Netfinity 5600 server will result in the SCSI
drive order being reported incorrectly. Failure to run this utility can also cause a loss of data.
3. Complete all other steps in this installation procedure before running the utility.
The utility on the diskette starts automatically and updates the drive order of the SCSI IDs. A progress
indicator displays during both stages of the utility (up to three minutes), followed by a message that
indicates successful or unsuccessful completion of the utility.
If the utility did not complete successfully, restart the server to retry the utility. If the utility repeatedly fails
to complete successfully, contact your authorized service representative.
If the utility completed successfully, remove the diskette and turn off the server; then, disconnect all power
cords and wait 60 seconds before you reconnect all power cords,and restart the server.
20

Copyright IBM Corp. 2000