IBM Netfinity 5Ux24D Tower-to-Rack Kit, Installation Instructions Manual

Page: 13 / 38

9. Remove the server bezel as shown below:
a. Locate the blue bezel-release lever
B
, on the left side of the server near the top front corner,
and move it upward.
B
A
Figure 3. Removing the server bezel
b. Swing the bezel
A
away from the server; then, lift the bezel tabs out of the tab openings on the
bottom of the server to remove the bezel from the server.
Store the bezel for potential future use.
10. Remove the right-side cover as shown below:
a. From the rear of the server, remove the four screws
B
that hold the cover
A
in place.
B
A
Figure 4. Removing the right-side cover
b. Slide the cover toward the rear of the server about 25 mm (1 in.); then, lift the cover away from
the server and store it for potential future use.
Preparing the server for rack installation
5