IBM Netfinity 5Ux24D Tower-to-Rack Kit, Installation Instructions Manual

Page: 16 / 38

15. For Netfinity 5600 servers, you must disconnect the LED panel cable from the LED panel; otherwise,
skip to step 16 on page 9.
a. Remove the two screws
A
that hold the LED panel assembly together.
D
C
B
A
Figure 9. Removing the existing cable from the LED panel assembly
b. Carefully unplug the connector
C
from the LED panel
B
.
c. Gently push the connector through the opening
D
.
Note: Be careful not to catch the LED connector on the two retention latches inside of the
opening on the bracket.
d. Gently pull the cable toward the rear of the server until the cable is free of the non-hot-swap bay
area; then, release the cable from the cable clip on the right side of the server.
e. If your LED panel cable is long enough to reach the new position for the LED panel assembly,
skip to step 17 on page 10 to continue the installation; otherwise, you must replace the existing
LED panel cable with the longer one that comes with this kit.
f. Disconnect the cables that plug into J8
E
and J10
A
on the processor board.
D
C
B
A
E
Figure 10. Removing the processor board to install the new cable
g. Release the processor board latch lever
D
; then, lift the processor board
B
out of the way.
Note: Be careful not to disconnect any other cables.
h. Disconnect the LED panel cable from J29
C
on the system board, just underneath where you
lifted the processor board.
8
5Ux24D Tower-to-Rack Kit Installation Instructions