IBM IntelliStation M Pro 6233, Hardware Maintenance Manual

Page: 66 / 156

3. Attach all cables to the hard disk drive.
4. If the drive is a removable media drive, remove the front bay panel in the cover.
5. Replace the side cover and reconnect the external cables and power cords. See
“Replacing the cover and connecting the cables” on page 65.
Installing drives in drive bays 4, 5, 6, 7, and 8
Before you begin, do the following:
Note: For IDE models, there are only four hard disk drives supported. The IDE
models are shipped with a hard disk drive installed bay 5. If you upgrade,
install hard disk drives in bay 4, 6, and 7 (in this order).
v
SCSI models are shipped with a hard disk drive installed in bay 9. If you
upgrade, install hard disk drives in bay 8, 7, 6, 5, and 4 (in this order).
v For information on installing SCSI drives, see the SCSI information on the
Software Selections CD that comes with the computer.
v
Review the “Safety information” on page 103.
v
Read the documentation that comes with the hard disk drive.
v
Turn off the computer and all peripheral devices.
v
Disconnect all external cables and power cords; then, remove the computer side
cover. See “Removing the cover and front bezel” on page 47.
To install a drive in drive bays 4, 5, 6, 7, and 8, do the following:
1. Touch the static-protective package containing the new drive to any unpainted
metal surface in the computer; then, remove the drive from the package.
2. Get two sliding rail mounts from the plastic bag located underneath the hard
disk drive cage.
3. Mount the sliding rails on the hard disk drive you want to install.
56
Hardware Maintenance Manual: IBM IntelliStation M Pro Type 6233 and 6850