IBM IntelliStation M Pro 6233, Hardware Maintenance Manual

Page: 65 / 156

Installing a drive in bay 1
Before you begin, do the following:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, refer to
“Handling static-sensitive devices” on page 43.
v
For information on installing SCSI drives, see the SCSI information on the
Software Selections CD that comes with the computer.
v Review the “Safety information” on page 103.
v
Read the documentation that comes with the hard disk drive.
v Turn off the computer and all peripheral devices.
v
Disconnect all external cables and power cords; then, remove the computer side
cover. See “Removing the cover and front bezel” on page 47.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic
devices, or transmitters) are installed, note the following:
v
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v
Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER:
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note
the following:
Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.
To install a drive in drive bay 1, do the following:
Note: You need an industry standard bay adapter bracket to install a 3.5-inch hard
disk drive in drive bay 1.
1. Touch the static-protective package containing the new drive to any unpainted
metal surface in the computer; then, remove the drive from the package.
2. Remove the EMC shield covering drive bay 1 and insert the drive into the empty
drive bay. Then, tighten the screws to hold the drive in place.
Installing options
55