IBM eServer 250 xSeries, User Reference Manual

Page: 154 / 186

140
IBM® xSeries 250: User’s Reference
NDIS 4.0 (Windows NT) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation and
recommended action are included with each message.
UNIX messages
This section provides descriptions of the Ethernet error messages for the SCO UNIX
LLI driver, and suggested actions to resolve each problem.
PCNTNW-NW-165 The device was not found at IOADDRESS.
Explanation: The Ethernet controller cannot be found at the I/O address specified.
Action: The Ethernet controller does not require a parameter for the I/O address. Remove the
I/O address parameter.
PCNTNW-NW-167 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the problem persists, go to “Starting
the diagnostic programs” on page 113 to run the diagnostic programs.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: None necessary, message is for information only.
PermaNet ™ Server: No Secondary Adapter Found. Grouping Mode is disabled.
Explanation: The failover option requires an adapter that is compatible with the device driver
of the Ethernet controller. No such adapter was found.
Action:
Make sure that the correct adapter is installed.
PermaNet Server: Problem Occurs on the Primary Adapter. Switching over to the Secondary Adapter.
Explanation: The system detected a problem with the primary Ethernet connection and has
transferred all network traffic to the secondary Ethernet controller.
Action:
Identify the cause of the failure on the primary Ethernet connection. Restoring the
operational state of the primary connection will cause the network traffic to automatically
transfer to the primary Ethernet controller.
PermaNet Server: Switching back to Primary Adapter.
Explanation:
The primary Ethernet connection is now operating correctly. Network traffic
will automatically transfer to the primary Ethernet controller.
Action:
None needed, message is for information only.
Table 23. NDIS (Windows NT) driver messages for the Ethernet controller.
Table 22. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet
controller.