IBM BladeCenter HS22V 7871, Problem Determination And Service Manual

Page: 88 / 258

To remove the battery, complete the following steps.
1.
Before you begin, read “Safety” on page v and “Installation guidelines” on
page 49.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 52 for instructions).
3. Remove the blade server cover (see “Removing the blade server cover” on page
55 for instructions).
4. If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 57).
5. Locate the battery on the system board.
6.
If there is a rubber cover on the battery holder, use your fingers to lift the
battery cover from the battery connector.
7. Release the battery by using your finger to press the top of the battery towards
the middle of the blade server and out of the battery connector.
8.
Use your thumb and index finger to lift the battery from the socket.
9. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
Use this information to install a battery on the system board in the blade server.
The following notes describe information that you must consider when you are
replacing the battery in the blade server.
v
You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
v
After you replace the battery, you must reconfigure the blade server and reset
the system date and time.
v
To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v
Heat to more than 100° C (212° F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note:
72
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide