IBM @Server pSeries 630 6C4, Installation Manual

Page: 66 / 180

CAUTION:
This unit has more than one power cord. To reduce the risk of electrical shock,
disconnect two power supply cords before servicing.
Note: This unit will only have two power cables if the redundant power supply feature
is installed.
Notes:
1. Servicing of the Model 6E4 can be performed with the system either in the vertical
or horizontal position. Servicing of the Model 6C4 is performed with the system in
the rack and placed into the service position. The service position for the Model 6C4
is described in “Placing the Model 6C4 into the Service Position” on page 53.
2. A highlighted number in a procedure step is referring to the numbered components
found in the illustration for that particular procedure.
Handling Static-Sensitive Devices
Attention: Electronic boards, diskette drives, and disk drives are sensitive to static
electricity discharge. These devices are wrapped in antistatic bags to prevent this
damage.
Take the following precautions:
v
If you have an antistatic wrist strap available, use it while handling the device.
v
Do not remove the device from the antistatic bag until you are ready to install the
device in the system.
v
With the device still in its antistatic bag, touch it to a metal frame of the system.
v
Grasp cards and boards by the edges. Hold drives by the frame. Avoid touching the
solder joints or pins.
v
If you need to lay the device down while it is out of the antistatic bag, lay it on the
antistatic bag. Before picking it up again, touch the antistatic bag and the metal
frame of the system at the same time.
v
Handle the devices carefully to prevent permanent damage.
50 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide