IBM @Server pSeries 630 6C4, Installation Manual

Page: 110 / 180

1 Outer Side Cover 5 Processor Fan Bottom Connector
2 Service Access Cover 6 Processor Cooling Fans Access
Cover
3 Processor Fan Amber LED 7 Processor Card Cooling Fan (Fan
#1)
4 Finger Holes 8 Model 6E4
Replacing a Processor Fan in a Non-Hot-Swap Environment
To replace a processor fan in a non-hot-swap environment, do the following:
1. Lift the processor fan access cover.
2. Place your thumb and index finger into the two holes located on the top of the
replacement fan.
3. Align the connector located on the fan assembly with the docking connector located
on the CEC backplane.
4. Insert and firmly press the replacement fan into the docking connector closest to the
back of the chassis.
5. Ensure the cooling fan access cover springs back to the closed position.
6. Replace the service access cover as described in “Service Access Cover
Replacement (Model 6C4)” on page 55 or “Service Access Cover Replacement
(Model 6E4)” on page 58.
7. On a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 54.
8. Power on the system as described in “Starting the System” on page 52.
9. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
94 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide