IBM AS/400e, Manual

Page: 72 / 85

__ 14. Refer to Figure 41 and support the bottom of the removable media device
assembly as you slide it half way into the next available position. Do not
push it any further.
__ 15.
Select option 2 (Install device for the action to be performed).
__ 16. Set the time delay for one minute.
01
Press the Enter key.
Note: Watch the light on the right side of the removable media devices. If
the light comes on and begins to blink rapidly, you have nine
seconds to slide the removable media device into place.
__ 17. When the light starts blinking, slide the removable media device in until it
seats properly. Push both blue handles in at the same time to lock the
removable media device into place.
__ 18. The green light will stop blinking and remain on solid when you properly
installed the removable media device.
__ 19. Return to the console and wait until the Concurrent Maintenance Results
display appears.
Press the Enter key.
__ 20.
When the Hardware Service Manager display appears, press F6 to print the
configuration list if you have a printer. You or a service representative may
refer to the configuration list in the future.
__ 21. Install the front cover for the expansion unit.
__ 22.
Press F12 twice and press the Enter key to return to the AS/400 Main
menu.
The installation of the removable media device is complete.
Figure 41. Installing removable media
60
Setting Up Your 5065 or 5066 Expansion Unit V4R5