__ 8.
Remove the SPCN cable (the SPCN cable between system unit and unit X)
from connector J15 on unit X. Do not disconnect the cable from your
system unit.
__ 9.
Use the latch that is shown at
A
to open the back cover on your
expansion unit.
__ 10.
If needed, use latch that is shown at
B
to remove the back cover.
__ 11.
Refer to Figure 17 on page 15 and install the optical cable that you removed
from unit X into the optical connector on your 5065 that is labeled
0
. The
optical cable should now run between your system unit and your 5065.
__ 12.
Plug the SPCN cable that you removed from unit X into the SPCN
connector J15 on your 5065. The cable should now run between your
system unit and your 5065.
__ 13.
Tighten the thumbscrews.
Figure 16. Opening or removing 5065 Expansion Unit back cover
14
Setting Up Your 5065 or 5066 Expansion Unit V4R5
Summary of Contents for AS/400e
