IBM AS/400e, Manual

Page: 23 / 85

__ 1. If you are installing your optical cables into an AS/400e system 620 or
AS/400e server 720 go to step 7. If you are installing your optical cables into
any other server, go to step 2.
__ 2.
Locate the 2688 OLP card (Figure 11) on the back of your system unit.
__ 3. Remove the terminating plugs from the optical card connectors.
__ 4. Push the optical cable that is labeled 0 into the top optical cable connector in
the system unit.
__ 5. Install the optical cable that is labeled 1 (for the redundant link) from the
expansion unit into the bottom optical cable card connector.
__ 6. Go to 7f.
__ 7.
If you are installing optical cables into an AS/400e system 620 or AS/400e
server 720 proceed as follows:
a. On the back of your system unit, locate the optical cable connectors that
have the following labels:
BUS 06 BUS 05
BUS 04 BUS 03
b. Choose the next available set of optical cable connectors.
c. Remove the terminating plugs from the optical cable connectors.
d. Install the optical cable that is labeled 1 into the even numbered optical
cable connector (
BUS 06
or
BUS 04
).
e.
Install the optical cable that is labeled
0
into the odd numbered optical
cable connector (
BUS 05
or
BUS 03
)
Example: If the optical cable connectors that are available are
BUS 06
and
BUS 05
:
1) Install the optical cable that is labeled 1 into
BUS 06
.
2) Install the optical cable that is labeled 0 into
BUS 05
.
f. Install the system unit back cover (Figure 12 on page 12) by doing the
following:
__ 1) Grip the upper corners of the cover.
__ 2) Align the pins with the slots.
__ 3) Push the cover in and down.
__ 4)
Go to “Chapter 5. Verifying Your New Configuration” on page 25.
Figure 11. 2688 OLP card
Chapter 2. Setting up your 5065 Expansion Unit
11