IBM 8676 - Eserver xSeries 335, Hardware Maintenance Manual And Troubleshooting Manual, Page: 74 / 172

1
2
ISM
IN
ISM
IN
ISM
IN
ISM
ISM
ISM
IN
IN
IN
OUT
OUT
OUT
OUT
OUT
OUT
24
25
23
46
First
ASM bus
Second
ASM bus
Complete the following steps to cable an ASM interconnect network:
1. Follow the instructions for cabling a C2T chain.
2. Connect an ASM interconnect module (which comes with the Remote
Supervisor Adapter) to the RS-485 connector on the Remote Supervisor Adapter
in the first server. If the network contains more than 23 servers, do the same on
the 24th server.
3. Connect an ASM link cable (which comes with the Remote Supervisor Adapter)
from the ASM interconnect module to the ISM connector in the first computer.
Insert a terminator into the second connector on the ASM interconnect module.
If the network contains more than 23 servers, do the same on the 24th server.
Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
starts so that you can save the new configuration information. See “Using the
Configuration/Setup Utility program” on page 9 for more information.
Some options have device drivers that you need to install. See the documentation
that comes with the option for information about installing any required device
drivers.
64
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide