IBM 8676 - Eserver xSeries 335, Hardware Maintenance Manual And Troubleshooting Manual, Page: 107 / 172

Note: See “System” on page 112 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
184
(Power-on password damaged)
1. Run the Configuration/Setup Utility program.
2. System board.
185
(Drive startup sequence information
corrupted)
1. Run the Configuration/Setup Utility program.
2. System board.
186
(Security hardware control logic failed)
1. Run the Configuration/Setup Utility program.
2. System board.
187
(VPD serial number not set.)
1. Set serial number in the Configuration/Setup Utility program.
2. System board.
188
(Bad EEPROM CRC #2)
1. Run the Configuration/Setup Utility program.
2. System board.
189
(An attempt was made to access the
server with invalid passwords)
v
Run the Configuration/Setup Utility program, and enter the
administrator password.
196
(Microprocessor mismatch error)
1. Move microprocessor in socket 1 to socket 2, and move
microprocessor in socket 2 to socket 1.
2. Microprocessor.
201
(Memory test error.) If the server does not
have the latest level of BIOS installed,
update the BIOS to the latest level and run
the diagnostic program again.
1. DIMM
2. System board
229
(Cache error)
1. Microprocessor
2. Optional microprocessor (if installed)
262
(DRAM parity configuration error)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
289
(DIMM disabled by POST or user)
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
3. System board
301
(Keyboard or keyboard controller error)
1. Keyboard
2. System board
303
(Keyboard controller error)
v System board
602
(Invalid diskette boot record)
1. Diskette
2. Diskette drive
3. Cable
4. System board
604
(Diskette drive error)
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
Chapter 6. Symptom-to-FRU index
97