IBM 79463AU, Installation And User Manual

Page: 77 / 142

Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power
source is removed. Before you disconnect the power source, make a
note of which LEDs are lit, including the LEDs that are lit on the
operation information panel, on the light path diagnostics panel, and
LEDs inside the server on the system board; then, see the
Problem
Determination and Service Guide for information about how to solve the
problem.
3. Remove the cover (see “Removing the cover” on page 49).
4. Disconnect the optical drive cable from the system board.
5. Remove the DVD drive filler if it is installed. locate the blue release tab on the
rear of the DVD drive filler; then, while you press the tab, push the DVD drive
filler out of the drive bay. Save the DVD drive filler for future use.
6. Remove the retention clip from the side of the DVD drive filler.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v
Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
Chapter 2. Installing optional devices
61