IBM 79463AU, Installation And User Manual

Page: 23 / 142

Table 1. Features and specifications (continued)
Integrated functions:
v Integrated Management Module (IMM),
which provides service processor
control and monitoring functions, video
controller, and (when the optional virtual
media key is installed) remote
keyboard, video, mouse, and remote
hard disk drive capabilities
v
Broadcom BCM5709 Gb Ethernet
controller with TCP/IP Offload Engine
(TOE) and Wake on LAN support
v
Five Universal Serial Bus (USB) 2.0
ports (two front and two rear of the
chassis, and one on the SAS/SATA
RAID riser card in which the optional
USB flash device with embedded
hypervisor software is installed)
v
Four Ethernet ports (two on system
board and two additional ports when the
optional IBM Dual-Port 1 Gb Ethernet
Daughter Card is installed)
v One System Management RJ-45 on the
rear to connect to a systems
management network. This system
management connector is dedicated to
the IMM functions. This connector is
active with or without the optional IBM
Virtual Media Key installed.
v One serial port
RAID controllers:
v
A ServeRAID-BR10i SAS/SATA
adapter that provides RAID levels 0, 1,
and 1E (comes standard on some
hot-swap SAS and hot-swap SATA
models).
v
An optional ServeRAID-MR10i
SAS/SATA adapter that provides RAID
levels 0, 1, 5, 6, 10, 50, and 60 can be
ordered.
v An optional ServerRAID M1015
SAS/SATA adapter that provides RAID
levels 0, 1, and 10 with optional RAID
5/50 and SED (Self Encrypting Drive)
upgrade can also be ordered.
v
An optional ServeRAID M5014
SAS/SATA adapter that provides RAID
levels 0, 1, 5, 10 and 50 with optional
RAID 6/60 and SED upgrade can also
be ordered.
v
An optional ServeRAID M5015
SAS/SATA adapter that provides RAID
levels 0, 1, 5, 10, and 50 with optional
RAID 6/60 and SED upgrade can also
be ordered.
Size:
v
Height: 43 mm (1.69 inches, 1U)
v
Depth: 711 mm (28 inches)
v
Width: 440 mm (17.3 inches)
v
Maximum weight: 15.4 kg (34 lb) when
fully configured
Acoustical noise emissions:
v
Sound power, idling: 6.1 bels
maximum
v
Sound power, operating: 6.1 bels
maximum
Electrical input:
v Sine-wave input (47 - 63 Hz) required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v
Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v
Input kilovolt-amperes (kVA),
approximately:
– Minimum: 0.090 kVA
– Maximum: 0.700 kVA
Notes:
1. Power consumption and heat output
vary depending on the number and type
of optional features installed and the
power-management optional features in
use.
2. The sound levels were measured in
controlled acoustical environments
according to the procedures specified
by the American National Standards
Institute (ANSI) S12.10 and ISO 7779
and are reported in accordance with
ISO 9296. Actual sound-pressure levels
in a given location might exceed the
average values stated because of room
reflections and other nearby noise
sources. The noise emission level
stated in the declared (upper limit)
sound-power level, in bels, for a random
sample of system.
Chapter 1. The System x3550 M2 server
7