IBM 79463AU, Installation And User Manual

Page: 111 / 142

v
If an administrator password is set, type the administrator password at the
password prompt. Start the Setup utility and reset the power-on password.
v Remove the battery from the server and then reinstall it. See the Problem
Determination and Service Guide on the IBM System x Documentation CD for
instructions for removing the battery.
v
For the Pass 8 level system board , change the position of the power-on
password switch (enable switch 5 of the system board switch block (SW3) to
bypass the power-on password check (see Table 5 on page 40 for more
information).
Attention: Before you change any switch settings or move any jumpers, turn
off the server; then, disconnect all power cords and external cables. See the
safety information that begins on page vii. Do not change settings or move
jumpers on any system-board switch or jumper blocks that are not shown in this
document.
The default for all of the switches on switch block (SW3) is Off.
Chapter 3. Configuring the server
95