IBM 7212 102, Service Manual, Page: 36 / 92

Step 19
You are here because the host system is an RS/6000 or pSeries host system.
This step verifies that the 7212 Storage Enclosure has been properly configured to
the host system.
Check the configuration of the 7212 Storage Enclosure to the host system software
by doing the following:
1. Log into the host system (AIX operating system).
Note:
You must have root authority to install or remove the 7212 Storage
Enclosure from the system. To obtain root authority, see your system
administrator.
2. At the system prompt, type
lsdev -Cs scsi
and press Enter. The command lists all of the SCSI devices that are connected
to the host system. Figure 7 shows an example of the screen that displays. The
screen lists:
1
Device name
4
SCSI address (begins with 7th digit)
2
Device Status
5
Description of the SCSI device
3
SCSI adapter slot number
3.
From the list of SCSI devices, identify the 7212 Storage Enclosure drive
features. These are listed as:
v
Differential SCSI 4mm Tape Drive
v
SCSI 4mm Tape Drive
v
SCSI DVD-RAM Drive
If the status of the 7212 Storage Enclosure drive feature is displayed as
Available, the device has successfully been configured. If the status is not
displayed as Available, refer to your host system manuals.
Is the 7212 Storage Enclosure properly configured to the host system?
NO
Go to Step 20.
YES Go to Step 20 to verify that the problem is fixed
hdisk0 Available 00-00-0S-0,0 2.0GB SCSI Disk Drive
hdisk1 Available 00-02-01-2,0 4.5GB 16 Bit SCSI Disk Drive
hdisk2 Available 00-02-01-3,0 16 Bit SCSI Disk Drive
rmt0 Available 00-02-01-4,0 Differential SCSI 8mm Tape Drive
rmt1 Available 00-02-01-5,0 4.0 GB 4mm Tape Drive
cd1 Available 00-03-01-1,0 SCSI Multimedia CD-ROM Drive
cd2 Available 00-03-01-2,0 16 Bit LVD SCSI DVD-ROM Drive
rmt2 Available 00-03-01-3,0 LVD SCSI 4mm Tape Drive
RBBTV547-1
Figure 7. Screen Display of SCSI Devices Attached to the host system
22
7212 Storage Device Enclosure Service Guide