IBM 689912U - IntelliStation Z - Pro 6899, Hardware Maintenance Manual

Page: 201 / 472

Administrator Password:
The administrator
password is used to restrict access to the
Configuration/Setup Utility program. If the administrator
password is activated, and you do not enter the
administrator password, the configuration can be viewed
but not changed.
Note
Type 6862, 6892, 6889, has Enhanced Security Mode.
If Enhanced Security mode is enabled and there is no
password given, the computer will act as if Enhanced
Security is disabled.
If Enhanced Security is Enabled and an administrator
password is given, the administrator password must
be entered to use the computer. If the administrator
password is lost or forgotten, the system board in the
computer must be replaced in order to regain access
to the Configuration/Setup Utility program.
For PC 700 computers, the administrator password is set
by jumpering an administrator password control jumper,
which can be on the riser card or the system board.
Note: The administrator password control jumper will not
remove the password.
Administrator Password Control Jumper on
Riser Card:
Refer to “Riser Card Layouts” on
page 388 for PC 700 Series riser cards that have an
administrator password control jumper. Pins shown on the
riser card are jumpered in the default (D) position.
Administrator Password Control
Jumper/Switch on System Board:
Refer to
“System Board Layouts” on page 322 and locate the
system board type you are servicing. Depending on the
system board, the password is set by a jumper or switch
block.
Jumper Position Results
1-2 (D) Administrator Password can
be set
2-3 Administrator password
cannot be set
Reference Information
191