IBM 325 8639, Hardware Maintenance Manual

Page: 58 / 145

PCNTNW-OS2-61 PCI device IRQ number mismatch.
Explanation: The IRQ number specified in the NET.CFG
file does not match with the IRQ number assigned in the
Configuration/Setup utility programs. The IRQ numbers
might be assigned automatically, or you might have
manually assigned the IRQ number.
Action: Remove the IRQ number in the NET.CFG file.
Or, see “PCI Bus Control” on page 34 for information on
setting the interrupt requests.
PCNTNW-OS2-64 The device was not found.
Explanation: The driver cannot find the Ethernet
controller in the server.
Action: Verify that the Ethernet enable jumper is set to
the default (enable) position. Go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run the
diagnostic utility.
PCNTNW-OS2-65 Device not found at IOADDRESS.
Explanation: The Ethernet controller cannot be found at
the IO address specified in the NET.CFG file.
Action: Verify that the IO address in NET.CFG matches
with the board. Otherwise, remove the PORT keyword
from the NET.CFG file.
PCNTNW-OS2-67 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet
controller on the PCI bus.
Action: Perform the following steps:
1. Verify that the Ethernet jumper on the system board
is set to the default, enable position.
2. Edit the NET.CFG file to change the BUSTYPE
keyword to PCI1.
3. If the problem persists, go to “General
Checkout/Diagnostics QAPlus/PRO” on page 1 to run
the diagnostic utility.
PCNTNW-OS2-73 Unable to allocate memory.
Explanation: The driver could not allocate memory for
the virtual board.
Action: Check the system configuration.
PCNTNW-OS2-80 The DMA parameter is not necessary
to PCI device.
Explanation: The Ethernet controller does not require a
DMA setting. This parameter is not a valid driver
parameter.
Action: Edit the NET.CFG file to delete the DMA
parameter.
PC Server 325 - Type 8639
53