IBM 0367, Manual

Page: 24 / 36

__ a. Click on Start .
__ b.
Click on Programs .
__ c. Click on IBM AS/400 Client Access .
__ d. Click on AS/400 Operations Console .
__ 5. Select Local Controlling System (LCS) to AS/400 System .
__ 6. Click on Next .
__ 7. Type the system name of the AS/400 you want to connect to. Then, click on
Next .
Note:
The system name can be a specified name and does not need to be
the actual system name. For example, you could name the system
ATLANTA
, when the actual name is 10-12345 .
__ 8. To accept the default value, Direct Cable Connection , click on Next .
__ 9.
Indicate which Operations Console actions you want to use with your
AS/400 system. If you installed
part number 97H7557 (Operations Console
cable) and part number 97H7591 (Remote Control Panel cable) , you need
to select both (Remote Control Panel and Console) .
__ 10. Then, click on Next . If you are only using the Remote Control Panel, go to
step 13. Otherwise, go to the following Note .
Note: If you chose console only on the Actions display, you will not get
any of the Remote Control Panel displays here.
If you chose Remote Control Panel only, you would not get any of
the
Console only displays here.
__ 11. Click on Next to allow the system to detect the console communications
port. System should find the port and select it automatically. If not,
manually select.
__ 12. Click on Next to confirm communications port. If no control panel cable
installed, go to step 15.
__ 13. Click on Next to allow the system to detect the Remote Control Panel
communications port. The system should find the port and select it
automatically. If not, manually select the port.
__ 14. Click on Next to confirm communications port.
__ 15.
Select
No, do not allow remote PCs to connect
. Then, click on
Next
.
Does Finish appear on your screen?
Yes No
↓
Click on Cancel . It has been detected that a component is not
installed on your PC. Resolve the missing component listed on
your screen and then start over.
Note: Refer to Operations Console Setup book after you have setup the
console, if dial-in support is required.
__ 16. Click on Finish . Operations Console automatically starts and tries to
connect.
__ 17.
Did you configure Operations Console for a Remote Control Panel?
Yes No
↓
Go to step 19 on page 19.
__ 18. Did the Remote Control Panel appear when setup was finished?
18
AS/400e 170 or 250 0367 Operations Console and 0381 Remote Control Panel Cable V4R5