__ a.
Select
AS/400 Operations Console Connection
.
__ b.
Click on
Configure
.
__ c.
Select
Dial out only
.
__ d.
Click on
OK
.
__ e.
Click on
Network
. Verify that the TCP/IP is selected in the
Dial out
Protocol
field. Then click on
OK
__ 15.
To complete the setup, do:
__ a.
Click on
Continue
.
__ b.
If you get a message that says
Remote Access Service has been
successfully installed
. Click on
OK
.
Note:
This message does not appear for all installs.
__ c.
Click on
Close
.
__ d.
Click on
Yes
to restart.
__ 16.
Important:
After the PC has restarted or any time Remote Access Service is either
installed or reinstalled, you need to install Windows NT Service Pack 3
(minimum level) before attempting to use Operations Console.
Note:
Do not remove the Service Pack CD until the PC is fully into its
restart. It will be accessed again after you click on
Yes
to restart.
After the restart to either install or reinstall the service pack, go to “Windows NT
Local Controlling System (LCS)”.
Windows NT Local Controlling System (LCS)
__ 1.
Did you install only a Remote Control cable (part number 97H7591)?
No
Yes
↓
Go to step 4 on page 17.
__ 2.
Plug the system unit power cord into an electrical outlet or an
uninterruptible power supply, if not already plugged in.
__ 3.
Look at the Function/Data display on the control panel.
__ a.
Does a
B M
appear in the Function/Data display?
No
Yes
↓
Go to step 3g on page 17.
__ b.
Is the Function/Data display lit?
Yes
No
↓
Before calling your hardware service representative, do the
following:
16
AS/400e 170 or 250 0367 Operations Console and 0381 Remote Control Panel Cable V4R5
