©Copyright Lotronic 2017
11
LED display instruction:
* {INTR}{DMX}{APP}{SET}{SND}{SEL} for status identification.
- {INTR} Indicates that the fixture is using the built-in effect. When the status flag is lit (INTR} alone, it is the built-in
effect play mode.
- {DMX} indicates that the fixture is controlled by the DMX signal. The status flag is only bright (DMX) for the
standard DMX control mode
- {INTR} {DMX} is a simple DMX mode that calls the built-in scenario via DMX signals.
- {SET} indicates that the fixture is in the system setup state.
- {SND} indicates that the motion of the pattern is controlled by the sound when the fixture is in the built-in mode.
- {SEL} In the set state, the indicator is lit to indicate that the current setting option is enabled.
* {INTR} the state of the digital display section.
- {AL} indicates the mix mode in the built-in mode (the scene play is extracted from each sequence).
- {P ###} Indicates the scene playback mode when the built-in mode is displayed. The displayed value is the scene
number.
- {SE ##} indicates the sequence playback mode when the built-in mode is displayed, and the displayed value is the
sequence number.
* DMX} the digital display part state.
* {INTR} + {DMX}the digital display part state.
- {A ###} Indicates the DMX address code for the fixture.
* {SET} the digital display part state.
- {SE ##} Indicates whether the digital display sequence is selected when the mixed mode of the built-in mode is
used.
(Note: {SEL} status flag indicates whether the sequence is selected.)
- {DR- ||} indicates the X mirror setting.
- {DR- =} represents the Y mirror setting.
- {DR- = ||} represents XY offset.
- {x ###} represents the X projection amplitude, the digital part is the full scale percentage value
(Note: {SEL} can be adjusted through the button on the board).
- {y ###} denotes the Y projection amplitude (Note: same as above).
- {r0FF} Indicates whether or not the remote control function is turned off.
- The virtual remote control of the mobile phone APP is the same as that described in the previous section.
* Extinguished: After a few hours of no operation, the digital part of the display will go out (Note: the screen function
with the specific model, some models do not have the function)
Remote control mode:
* [INTR] key: Enter the mix mode built-in.
* [DMX] key: Professional DMX mode.
* [E-DMX] key: easy DMX mode.
*[1-9] key: digital number from 1 to 9
- In the built-in mix mode, press the [1-9] button to enter the scene playback mode. The
number entered is the scene
- When the built-in sequence is played, press the [1-9] button to select the serial number.
- In DMX mode or E- DMX mode, press the digital button to set the address code.
- In the setting mode, you can select the projection range when setting the projection
angle.
* [+][-] key:
- In the scene playback mode, press this key to adjust the scene number.
- Press this key to adjust the serial number in the sequence play mode.
