www.ismacontrolli.com
page 5
DBL394en | 1
st
Issue rev. 8 | 07/2022
TERMINAL BLOCK
230~V ±10%
*
F
N
U Y M Y1 Y2
Floting only sink (connect Y1, Y2 to M)
*
(*) In order to use the floating control the only possible connection is * Floting only sink (connect Y1, Y2 to M) between terminal M and Y1/
Y2. Do not connect Y1/Y2 to phase (F) or neutral (N).
LABEL
DESCRIPTION
FUNCTION
WIRE SIZE
MAX. WIRE LENGTH
F
230 V AC
Power Supply
AWG16
(min 1mm
2
- max 1.5mm
2
)
75 m
N
Y
0..10 V DC
Modulating Control
Input
AWG20
(min 0.5mm
2
- max 1.5mm
2
)
200 m
M
0 V (Common)
Y1
Open
Floating Control Input
AWG20
(min 0.5mm
2
- max 1.5mm
2
)
200 m
Y2
Close
V+
16 V DC
Voltage Output
(max 25 mA)
AWG20
(min 0.5mm
2
- max 1.5mm
2
)
200 m
M
0 V (Common)
U
2÷10 V DC
Feedback Output Signal
AWG20
(min 0.5mm
2
- max 1.5mm
2
)
200 m
M
0 V (Common)
Note: To avoid damages to electronic components caused by the PCB bending, do not press too much while fixing the terminal block.
GROUND CONNECTIONS
Connect the ground terminal to the proper screw labelled with the ground symbol as shown in the picture here below.
SAFETY PRESCRIPTIONS
230 V products
• Install on the power supply line a protecting device to avoid short circuits (fuse or magneto-thermic) according to the specifica-
tions in force;
• in case of accidental removal of the cover to make sure that power is disconnected before working on the actuator or near it;
• the products are maintenance free.
