46
access control list will be able to connect to your Access Point. When
Deny Listed
is
selected, these wireless clients on the list will not be able to connect the Access Point.
Advanced
Choose
Network Setup > Wireless
>
Advanced
and the following page appears. In this
page, you can configure the wireless advanced parameters. It is recommended to use the
default parameters.
The following table describes parameters in this page:
Field
Description
Fragmentation
Threshold
(256-2346)
Set the threshold of fragmentation length. If the length of a
packet is greater than the value, the packet is automatically
fragmented into several packets. Because too many packets
lead to low performance of the wireless network, the value of
Fragmentation Length
cannot be too small. The default
value is 2346.
RTS Threshold
Set the CTS/RTS threshold. If the length of a packet is
greater than the value, the router sends an RTS frame to the
destination station to negotiate. After receiving the RTS
frame, the wireless station responds with a Clear to Send
(CTS) frame to the router, indicating that they can
communicate with each other. The default value is 2346.
Data Rate
Choose the transmission rate of the wireless data from the
Summary of Contents for DWA-N150U Series
