iBall Baton DWA-N150U Series, Manual

Page: 23 / 95

18
The following table describes the parameters in this page:
Field Description
VPI
Virtual path identifier (VPI) is the virtual path between two points in
an ATM network. Its valid value is in the range of 0 to 255. Enter
the correct VPI provided by your ISP.
VCI
Virtual channel identifier (VCI) is the virtual channel between two
points in an ATM network. Its valid value is in the range of 32 to
65535. (0 to 31 is reserved for local management of ATM traffic)
Enter the correct VCI provided by your ISP.
Encapsulation
You can select LLC/SNAP or VC-Mux . In this example, the
encapsulation mode is set to LLC/SNAP .
Connection
Mode
There are five WAN connection types: PPPoA , PPPoE , IPoE ,
1483 Routed , and Bridge .
PPPoE/PPPoA: Need to enter PPP username and password
provided by your ISP.
IPoE/1483 Routed: You can select Attain IP Automatically or
IP Manually .
Bridge: You need to dial-up on PC to connect to the Internet.
IP Protocol
You can select it from drop-down list:
Default Route Enable or disable it.
DNS Settings
You can select Set DNS Automatically or Set DNS Manually . If
you select Set DNS Manually , enter DNS server provided by your
ISP.
For other entries which are not mentioned above, you can keep them as defaults.
Step 2 Wireless Quick settings
In following page, you can select wireless band, set SSID and encryption. For wireless
security, it is recommended to set the encryption mode to WPA2, and then enter a
password.