28
Tech Support:
(
877) 591-2491
When installing in an R40 light fixture you will want to
loosen this nut and move the plate as far back as possible.
If this wing nut is properly tightened, it will be sufficient to
securely hold your LightSpeaker
®
permanently in place.
The R30 light fixture uses another entirely different method
to secure the LightSpeaker
®
to the down lighting fixture.
It is held by means of two wire “V springs”. These are
sometimes but not always the springs that hold the trim
ring to the light fixture; more often they are the two wing
shaped springs that when viewed out of the light fixture
form, as the name implies, a spread out letter “V”. If you
have removed the existing trim ring and any included
reflector, then you will have already encountered these “V
springs” and know how they operate. Do not confuse these
springs with the “coil springs” which attach the reflector to
the down lighting fixture.
Installing and Removing the Lens:
A)
Removal
BEFORE
your LightSpeaker
®
is installed.
1)
While holding the LightSpeaker
®
in the palm of your hand
rotate the unit until one of the holding tabs is facing up.
2)
Using a fingernail, common screwdriver or other small
flat object, gently push down and then out on the tab, easing
it out through the opening in the LightSpeaker
®
housing.
