21
Tech Support:
(
877) 591-2491
3)
Be certain this trim ring contacts the
ceiling uniformly all of the way around your
LightSpeaker
®
and that the LightSpeaker
®
itself
is seated securely into the electrical socket.
Note: sometimes the metal clip that holds the
Edison socket to the socket plate prevents the
LightSpeaker
®
from seating completely and
making a good electrical connection. If this occurs
simply bend the tabs out and up 1/8” -1/4”.
Step 8B:
Removing your LightSpeaker
®
from a recessed
lighting fixture.
Remove the lens (See Installing and Removing the
Lens), and while pushing up lightly apply a 1/4” turn in a
clockwise direction. Gently pull down on the light bridge.
See “Removing the lens” below.
Step 9:
Pairing The Transmitter to the speakers
A)
Attach the power cord at the “DC IN” connector on
the back of the Transmitter.
B)
Turn on the Power Switch.
C)
Pairing - This fully automated process will tell the
transmitter where each LightSpeaker
®
is located,
allow you to control each zone separately and make
your LightSpeaker
®
system secure from other nearby
systems. After you have set the zone switch on each
speaker to the correct zone and you have installed
your light speakers into the correct sockets in the
correct zones (i.e. Zone 1 speakers in Zone 1, Zone 2
