5
Workmaster E Series Bench Assembly:
Step 1:
Attach beam connector plates to the ends of the bench support beams using the 5/16-18 x .75 hex head bolts
and 1/4 flat washers supplied as shown. DO NOT TIGHTEN THE HARDWARE. If you have ordered a TE1
Electrical Channel it installs in the same way as the standard support beam and can be installed in the front or
rear beam location. (See Part 2, page 17)
Step 2:
Place worksurface topside down on smooth flat surface being sure to protect it from damage by foreign
objects. IAC recommends the use of packing type blankets or clean cardboard. Place the support beams on
the worksurface with the open side toward the center of the worksurface and align the slots of the support
beams over the threaded inserts in the worksurface as shown. Thread 1/4-20 x .75 hex head bolts and 1/4 flat
washers into the threaded inserts to attach the beams to the worksurface. DO NOT TIGHTEN THE
HARDWARE.
