3. Make a note of the new snapshot File Name. Each snapshot is assigned a random number
attached to the end of the file name to distinguish between snapshots taken within the same
second.
5. Click
OK
to save the the *.bmp snapshot.
The snapshot files are named according to the following standard:
IPADDRESS_CHANNEL_YYYYMMDD_HHMMSS_RANDOMNUMBER.bmp.
For example, a 192.0.0.63_01_20100920_113425_7998234.bmp snapshot was taken from an
Annexxus 32VD14 network camera on the 192.0.0.63 IP address (default IP address), Video
Channel 1, September 20, 2010 at 11:34:25 AM.
4 Appendixes – Annexxus Finder
Annexxus Finder locates all Annexxus cameras on the network and displays important
information about each individual device, including IP Address, Subnet Mask, Port number,
Firmware version, and MAC Address. Use the Annexxus Finder application to configure the IP
Address and the Subnet Mask for the detected Annexxus devices as well as reset the devices’
passwords to the factory default
1234
.
4.1 Installing Annexxus Finder
Each Annexxus Network camera is accompanied by the Resource CD. Insert the CD into your
system's CD drive. On the CD, locate and open the Annexxus_Finder folder.
To install the Annexxus Finder application, follow the steps below:
1. Double-click the
Setup.exe
file.
2. In the first setup window, click
Next.
3. In the
Select Installation Folder
setup window, select installation drive and folder by clicking
Browse...
or keep the default installation folder (recommended). Select the
Everyone
radio
button and click
Next
.
4. In
Confirm Installation
setup window, click
Next
to proceed with the installation.
5. Wait while the Annexxus Finder software is installing onto the local system.
6. The WinPcap installation will be automatically launched. You must install WinPcap library for
the proper functioning of the Annexxus Finder application. In the
WinPcap 4.0.2 Installer
window,
click
Next.
7. In the following WinPcap installer window, click
Next.
8. In the WinPcap
License Agreement
window, read the WinPcap license terms (scroll to read the
entire document). Then click the
I Agree
button.
9. Wait while WinPcap is installing onto the local system. Wait for the
Installation Complete
setup
window to be displayed and click
Close
. Annexxus Finder is now installed on your system and is
ready to use.
Important
To virus protection software users: make sure to allow the WinPcap library to operate on your
system.
21
