9
Building No.2, Link Road, Malad (W), Mumbai - 400064.
Tel: 022-66939916/17/18;
Website :
E-mail :
338, New Sonal Link Service Industrial Premises Co-op Society Ltd,
Mfgd by: Innovative Instruments & Controls LLP
i
i
Proportional Band
Integral Time
Derivative Time
Slow Response
Over Shoot or Oscillations
Slow Response
Instability or Oscillation
Slow Response or Oscillation
High Over Shoot
Decrease PB
Increase PB
Decrease Int
Increase Int
Decrease Dt
Increase Dt
Adjust
Symptom
Solution
Table: 3
NC
: Normally Close terminal of relay
NO
: Normally Open terminal of relay
OP1
: Output 1
OP2
: Output 2
compensation
C.A. : Control Action
CJC : Cold junction compensation
CM
: Common terminal of relay
LWC : Lead wire (Length)-
SP1
: Set Point Value (set temp.)
SSR
: Solid State Relay
T/C
: Thermocouple
PV
: Process Value (actual Tmp.)
ABBREVIATION :
TEMP (°C)
SP
AMB
O/P
HYSTERISIS
ON
ON
ON
OFF
OFF
HEAT LOGIC/ ON-OFF
TIME
Fig : 3.1
TEMP (°C)
SP
AMB
O/P
O/P
HYSTERISIS
ON
ON
ON
OFF
OFF
TIME
Fig : 3.2
COOL LOGIC/ ON-OFF
USER GUIDE
: -
ON-OFF ACTION :
In this mode, Output (Relay/SSR) remains ON till actual temperature reaches to the set point value. On
reaching to SP, Output turns OFF & remains OFF till actual temperature drops down (in Heat Logic) or raises (in Cool Logic)
equal to hysterisis set by user. (As shown in Fig. 3.1 & 3.2)
(2) Substantial change in SP from previous auto tuning value.
AUTO TUNING MODE :
In this mode, Controller learns the process characteristics by itself and calculates the required P,I &
D values. It can be performed at any time after power ON but, it is best to start it when the process is at Ambient temperature
in order to minimize overshoot & undershoot. Auto tuning is applied in case of :
(3) Control accuracy is not satisfactory.
(1) Initial set up for a new process.
If the control performance by using auto-tuning is still unsatisfactory, User can apply further adjustments of P,I & D values as
shown in Table:3 below.
AUTO TUNING MODE :
To enter in this mode, Press and hold SHIFT key for minimum 3 sec.
This function will be executed only if selected control action is PID & Auto tune is
Enable.
User can cancel or abort this feature by setting this parameter to NO.
The Auto-tuning function can be initiated by setting this parameter to YES. The
decimal of LSB flashes till auto tuning function is in progress. During Auto-tuning,
The controller learns the process characteristics by itself & calculates required P, I
& D values.
AUTO
TUNING
MODE
NO
PARA
METER
UPPER
DISPLAY
LOWER
DISPLAY
DESCRIPTION
DEFAULT
OIM Px-X28 V2.0 Page 9 of 9
