I-Tech I-TECH LA8000, User Manual

Page: 22 / 44

IACER Srl 18 MNPG179
-
It is advisable to suspend therapeutic treatment if any problems arise
during use.
-
It is strongly recommended to turn off the machine when the handpiece
is not actively in use, in order to avoid overheating.
WORKING PROBLEMS
-
DO NOT OPEN the unit, in it there are HIGH ELECTRIC VOLTAGE, which
can be very DENGEROUS.
Connections
At the back of the machine is an integrated power supply module. This
features a three-pole connector for the power cord, a removable fuse-
holder that holds two fuses (refer to
Technical features paragraph) and a
two-way main switch.
Insert the female three-pole plug of the power cord in the integrated
module, making sure to fit it perfectly inside the connector.
Insert the interlock key in the dedicated connector.
Connect the pedal, inserting the connector in the relative socket on the rear
panel.
Connect the handpiece in the relative socket on the front panel, fastening
carefully the connector so that the mark on the connector of the handpiece
will be aligned with the mark on the front panel of the device.
ATTENTION: do not strain the connection and screw only to its limit. A
wrong connection or a forced connection could damage the optical fiber
of the handpiece.
Routinely check the condition of the power cord and the cable connected to
the handpiece/applicator: these must be neither damaged nor worn.
Start-up and protection password
After installing and positioning the machine as instructed above and fitting
the cable of the handpiece in the relative connector, plug the machine into
the (230 Vac) mains socket and turn on the main ON/OFF switch on the rear
panel.
The user interface of the device is represented by the LCD display: here are
displayed the error messages, the operation messages and the functioning
status of the device during the therapy treatment. Turning the device on
powers the I-TECH LA8000/10000 and the backlit LCD display lights up,
indicating that the equipment is ready to start.