I-Tech CMS-6R4, User Manual

Page: 59 / 123

5-37
Confi guration
2. When the command prompt appears, invoke the /CP command as
described below. The menu shown in Figure 5.16 will be displayed.
a)
All Ports: To copy parameters to all CMS ports, type
/CP
and then
press [Enter] .
b) Range of Ports: To copy parameters to a range of Serial Ports, type
/CP m-n and then press [Enter] . Where m and n are CMS port
numbers that specify the beginning and end of the desired range. For
example, to copy parameters to ports 3 through 5, type
/CP 3-5
and then press [Enter] .
c) Several Ports: To copy parameters to several Serial Ports, type
/CP m,n,x
[Enter] . Where
m
,
n
and
x
are the numbers for the
desired ports. For example to copy parameters to ports 3, 5, and 7,
type
/CP 3,5,7 [Enter]
.
d)
Combination:
To invoke the /CP command in a manner where a
range of Serial Ports is specified, along with other port(s) outside the
range, type
/CP m-n,x
[Enter] . Where
m
,
n
and
x
are Serial Port
numbers. For example to copy parameters to Ports 2 through 4, plus
Port 6, type
/CP 2-4,6
and then press
[Enter]
.
3. Selecting Parameters: To select parameters to be copied, key in the
number for the desired parameter, press
[Enter]
, and then follow the
instructions in the submenu. Note that it is not necessary to define all port
parameters; for example, the /CP command could be used to select only
the Baud Rate for all specified ports.
4. Clear Menu: After defining several parameters, if you wish to clear the
/CP menu and start again, type - (dash) and press [Enter] . The Copy
Parameters menu will be reset.
5. Exit Without Copy: To exit from the Copy Parameters menu without
copying selected parameters to the selected Serial Ports, type
X
and then
press [Enter] . The CMS-6R4 will exit from the Copy Parameters menu.
6.
Copy Parameters:
When you have finished selecting parameters, press
[Esc]
to copy the selected parameters to the Serial Ports. If the "Sure"
confirmation prompt is displayed, type
Y
to proceed or
N
to abort the
command.