2. Installation Setup
2.1 Install CCE900-IP-T Transmitter
1. The DVI input of the CCE900-IP-T is
[DVI-I]
(VGA + DVI-D). You
can
use the accessory of VGA-to-DVI cable to connect CCE900-IP-
T to
the PC VGA-Out. Or you can prepare a DVI-to-DVI cable to
connect CCE900-IP-T to the PC DVI-Out.
2. There is a
[VGA-Out]
on the CCE900-IP-T for the VGA loop-out.
It is only available when the input video is DVI-A (or VGA). You
can attach a VGA monitor on this
[VGA-Out]
for local display.
3. Use accessory of audio cable to connect CCE900-IP-T
[Line-
IN]
to the PC Line-Out.
4. Use optional accessory of Mini USB-to-A cable to connect
CCE900-IP-T
[Mini USB]
to PC USB.
5. Use optional accessory of IR blaster cable to connect CCE900-
IP-T
[IR Out]
and adjust the IR blaster LED face to the IR
receiver of your Media Center PC, TV tuner card or DVD player.
6. Use CAT5e/6/7 cable to connect CCE900-IP-T
[Ethernet]
to
the Ethernet switch (or directly to the CCE900-IP-R). All of
CCE900-IP-T and CCE900-IP-R must be put in the same
network and should not be inter-connected with router.
7. Use the included 12V DC power adapter to connect CCE900-
IP-T
[DC IN]
power socket and plug the power supply to
wall.
8. There is a [Status] LED and 2 RJ45 LEDs on the CCE900-IP-T,
please refer to the below table for the status of CCE900-IP-T:
[Status] LED
RJ45 LED
Red
Green
Green
Orange
On
Blink
On
On
On
3
Status
System OK, network is not
connected
System failed
System OK, network is connected
