Step 5:
After the
[Reset]
button is released, in case of CCE900-IP-
R,
the
[Power]
LED will become orange; in case of CCE900-
IP-T, the
[Status]
LED will become orange blinking. This
indicates the device is entered Setup Mode and you can
start to setup and get access to the HTTP server of the
device. If you are not in this status, any setup process is in
vain.
Step 6:
Use a straight Ethernet Cable to connect the PC with the
device. (The
[Status]
or
[Power]
LED is still lit in orange.)
Step 7:
Ping the connected device through the sequence, Start,
Run, cmd, ping [TX IP] or ping 192.168.168.22 (for RX). If
you receive the reply, it means the device is ready for
setup mode. Use IE browser to open the setup page. For
CCE900-IP-R, the URL is
http://192.168.168.22.
For
CCE900-IP-T, the URL is
http://[TX
IP]
. In this page, you
can setup IP address, subnet mask, gateway, device
name, network protocol and destination.
Device Name:
the name of the device.
13
