7
1
Rack mounting
Step 3
Place the rack mounting brackets (included) on both
sides of the recorder and fix them with the rack
mounting bracket fixing screw (included) (×6).
Secure them using the rack mounting bracket fixing screw
(included) (×6).
Tightening torque: 0.88 N·m ~ 1.08 N·m (0.65 lbf·ft ~ 0.80 lbf·ft)
Rack mounting bracket fixing screws (included)
Rack handle (included)
Rack mounting brackets (included)
Rack handle (included)
Step 4
Install the recorder in the rack by using four rack
mounting screws.
Secure using the rack mounting screws (×4).
Tightening torque: 2.0 N·m ~ 2.4 N·m (1.48 lbf·ft ~ 1.78 lbf·ft)
Rack mounting screws (M5 × 12 mm, locally procured)
Important:
• The operating temperature range of this product is
0 °C ~ +45 °C {32 °F ~ 113 °F}.
* HDDs deteriorate at high temperatures, affecting their
service life. It is recommended that the product be
used at a temperature of about +25 °C {77 °F}.
• The following measures should be taken when installing
the rack to ensure that the product is used within the
operating temperature range.
嵣
Install a fan or other equipment to lower the
temperature inside the rack.
嵣
Allow a distance of at least 1U (44 mm {1-23/32
inches}) between the top and bottom of the product.
嵣
Do not put doors on the front of the rack or block
the sides.
• The recorder weighs over 10 k
g
{22.1 lbs}. Be careful
not to drop the recorder when installing it into a rack.
Dropping may cause damage, deformation of the
recorder, or injury.
Install the recorder in an EIA standard 19-inch rack (Depth:
550 mm or more).
Note:
• Use four M5 × 12 mm screws (locally procured) to install
the recorder in a rack.
• The illustration on this page is schematic. Details of the
shape are omitted.
Installation procedure
Step 1
Remove the five rubber feet from the bottom of the
recorder.
Use a screwdriver to remove the screws holding the rubber feet.
Remove rubber feet
Step 2
Attach the rack handles (included) to the rack
mounting brackets (included).
Fix them using the screws (included) (×4) and the washers
(included) (×4) for the rack handle.
Tightening torque: 2.0 N·m ~ 2.4 N·m (1.48 lbf·ft ~ 1.78 lbf·ft)
Washer (included)
Screws for the rack handle (included)
Rack mounting bracket (included)
Washer (included)
Rack handle (included)
Note:
• The rack mounting bracket (included) has two types of
fitting holes to adjust the protrusion of the front rack. Use
either of them depending on the installation conditions.
Standard fitting holes
Fitting holes for the front position (about 15 mm {19/32 inches})
