16
GAME REPAIR
SCALE ASSEMBLY SERVICE
BIN MOTOR
1. The bin motor is used to push the candy into the
win chute, or return it to the playfield.
2. Check to be sure the problem lies with the bin mo-
tor assembly and not with the Main P.C. Board,
scale board, or wiring.
3. Remove enough candy from the game so the
scale assembly can be tipped forward.
4. Remove the drive belt from the motor pulley.
5. Remove the pulley from the motor.
6. Remove the motor by removing the 3 screws that
attach it to the housing. Unplug the connector to the
motor.
7. Re-assembly in reverse order.
SCALE BOARD ASSEMBLY
The scale board assembly is the "nerve center" for
the scale as well as the scale dial assembly. The
scale board is the interface for the strain gage
(scale), dial L.E.D.'s, dial servo motor, scale bin mo-
tor, and scale bin position sensors. If any of the
above items are not working, there is a good chance
that the scale board is defective.
Remove the board as follows:
1. Remove enough candy from the game so the
scale assembly can be tipped forward.
2. Remove the 2 Phillips head screws that hold the
scale board mounting bracket to the scale housing.
3. Unplug the scale board assembly and remove
from the game.
4. Install in reverse order.
4. Unsnap the bulb from the bulb holder. This
can be done by pushing on the release but-
ton while pulling on the bulb.
5. Replace in reverse order.
6. Be sure the bulb is snapped securely in
place..
7. Snap the clear plastic bulb retainer back into
place.
PRIZE FENCE
REPLACEMENT
1. Remove all A.C. power from the game.
2. Unlock and open the front door.
3. Carefully unbolt the 3 bolts and 2 screws
holding the prize fence to the play field.
4. Remove the old prize fence.
5.
Assemble in reverse order.
PRIZE SENSOR
REPLACEMENT
1. Remove all A.C. power from the game.
2. Unlock and open the front door.
3. Remove the cover to the prize chute to ac-
cess the sensor
4. Remove the 2 plastic hex spacers securing
the sensor board to the bracket.
5. Carefully remove the sensor board from its
mounting studs.
6. Reassemble in reverse order using a new
prize sensor band.