DO-IT-YOURSELF MAINTENANCE
6- 25
G290A02L-GAT
HEADLIGHT AIMING ADJUST-
MENT
HID Type (If installed)
WARNING:
If you need headlight aiming ad-
justment, have your vehicle in-
spected by your Hyundai Dealer.
Don't attempt to replace or inspect
the HID headlight bulb to prevent
danger of an electric shock.
Vertical
Aiming
Horizontal
Aiming
Before performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper & rear
bumper down several times. Place
the vehicle at a distance of 3 m
(118 in.) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools). Have the driver or
equivalent weight placed in driver's
seat.
4. Clean the head light lenses and
turn on the headlights (low beam).
5. Open the hood.
6. Draw the vertical line (through the
center of each headlight) and the
horizontal line (through the center
of each headlight) on the aiming
screen.
And then, draw the parallel line at
30 mm (1.18 in.) place under the
horizontal line.
!
G290B02L-GAT
Adjustment After Headlight As-
sembly Replacement
G290B01L
L
W
H
H
Cut-off line
Ground
line
If the vehicle has had front body
repair and the headlight assembly
has been replaced, the headlight aim-
ing should be checked using an aim-
ing screen as shown in the illustra-
tion. Turn on the headlight switch.
(Low Beam Position)
"P"
Horizontal line
15mm (0.59in.)
30mm (1.18 in.) Vertical line
7. Adjust each cut-off line of the low
beam to the parallel line with a
phillips screwdriver - VERTICAL
AIMING.
8. Adjust each cut-off line of the low
beam to each vertical line with a
phillips screwdriver - HORIZON-
TAL AIMING.
G290A02L
General Type
