![background image](http://html.mh-extra.com/html/hyundai/s2f57-ac300/s2f57-ac300_installation-instructions-manual_2197280004.webp)
Genuine Accessories
N
O
T
E
N
O
T
E
A. Remove the Fuse Panel Cover.
B. Gently pull the Weatherstrip back from the dash area.
C. Using a trim removal tool, remove the Driver’s Side Dash End Cap Panel
by prying outward to disengage the three (3) Pressure Clips.
D. Store the removed parts in a safe location for reinstallation.
N
O
T
E
#2 Phillips Screwdriver
5
4
Caution! Be careful not to damage the parts or clips during removal.
A. Using a Trim Removal Tool, release the Retaining Tab as shown.
B. By hand, dislodge the Lower Dash Panel.
C. Disconnect any Electrical Connectors including OBDII Connector from
the Lower Dash Panel, if applicable.
D. Store the removed part in a safe location for reinstallation.
Caution! Do not damage the Lower Dash Panel, OBDII Connector or
Electrical Connectors.
N
O
T
E
Caution: Do not damage the Dash Panel, Fuse Panel Cover or Dash End
Cap. Make sure no pressure clips remain in the dash board.
A. Dislodge the Weatherstrip from the Driver's Kick Panel along the Door
Threshold Panel.
B. Remove the Driver's Door Threshold Panel.
C. Remove the Hood Release Lever.
D. Remove the Driver's Kick Panel.
E. Store the removed parts in a safe location for reinstallation.
3
Trim Removal Tool
6
Trim Removal Tool
A. Using a Phillips Screwdriver, remove the two (2) phillips screws
from the side of the Lower Dash Panel as shown.
B. Using a Phillips Screwdriver, remove the one (1) phillips screw
from the bottom of panel as shown.
C. Store the removed screws in a safe location for reinstallation.
8mm Socket, Extension, Trim Removal Tool
Caution: Do not damage the Lower Dash Panel.
Pressure
Clips
Fuse Panel
Cover
Dash End Cap Panel
Phillips Screws
Pressure Clips
Retaining
Tab
Clips
Hooks
Press the 8mm
Socket with
Extension onto
the Tabs
Pry the Hood
Lever using a
Trim Removal Tool
Plastic Push Clip
Revision Date
5/03/2018
Page 4 of 11