Genuine Accessories
12
N
O
T
E
11
Wire Cutters
N
O
T
E
A. Disconnect the 74-pin CAN Connector from the Driver's Kick Panel area.
B. Connect the corresponding Remote Start Harness connector to the 74-pin
CAN Connector, and the vehicle connector.
N
O
T
E
A. Using one (1) Wire Tie, secure the Remote Start Harness, as shown.
B. Trim excess Wire Tie material.
Ratchet, Torque Wrench, Extension, and 12mm Socket
A. Remove the 12mm Dash Bolt from the bracket located by the Fuse Box, as
shown.
B. Route the Ground wire, as shown over to Dash Bolt area.
C. Insert the 12mm Dash Bolt into the Ground wire Ring Terminal, and
reinstall.
D. Torque to 19.2 N-m (1.96 kgf-m, 14.16 lb-ft).
Caution! Make sure the Remote Start Harness does not interfere with the
re-installation of the Driver's Kick Panel.
13
Wire Cutters
N
O
T
E
A. Using two (2) Wire Ties, secure the Remote Start Harness to the vehicle
harness as shown.
B. Trim excess Wire Tie material.
10
Dash
Bolt
Wire Ties
Remote Start
Harness Fuse
Remote Start
Harness
SJB
74-Pin CAN
Connector
Wire Tie
Ground
Wire
Revision Date
5/03/2018
Page 7 of 11
