Genuine Accessories
Wire Cutters
Caution! Do not damage the Lower Dash Panel, OBDII Connector or Electrical Connectors.
N
O
T
E
A. Route the 16-Pin CAN Connector and Harness behind the Fuse Box.
B. Locate the factory 16-Pin Female CAN-Connector, found on the back side of the Fuse box, as shown above.
C. Disconnect the 16-Pin CAN Connector from the back side of the Fuse Box.
NOTE
: The factory 16-Pin CAN Connector may be difficult to disconnect, make sure to fully press in the release tab before pulling out the connector.
D. Connect the corresponding Remote Start T-Harness Connector to the 16-Pin CAN Connector and Fuse Box (back side).
E. Using one (1) Wire Tie, secure the 16-Pin CAN Connector to Vehicle Harness as shown.
F. Trim excess Wire Tie material.
A. Connect the corresponding Remote Start OBD II Connector to the OBD II Connector disconnected from Lower Dash Panel.
B. Lock connectors in place tightly using two (2) Wire Ties behind connector slots to prevent separation between factory OBDII and Remote Engine Start OBDII
connector as shown.
Wire Cutters
6
7
Ensure 16-Pin CAN Connector is fully seated in the Fuse Box.
N
O
T
E
Remote Start
OBDII Connector
Factory OBDII
Female Connector
16-Pin CAN
Connector
Wire Tie
Fuse Box
Back Side
Fuse Box
Back Side
16-Pin CAN
Connector
Wire Ties (2)
Slots
Wire Ties
Revision Date
01/02/2019
Page 5 of 10
