Genuine Accessories
A. Connect the 20-Pin Connector (black) to the Control Module.
B. Connect the 4-Pin Connector (black) to the Control Module.
C. Verify the following:
- Control Module is attached to Antenna Bracket.
- Both black 6-Pin connectors are attached to Antenna and Control Module.
Ensure that each Connector is fully seated in the Control Module and in the Antenna.
8
9
Wire Cutters
N
O
T
E
A. Position the Control Module Assembly (Control A Antenna H Antenna Bracket) close to the Grommet on Bulkhead, as shown.
B. Using two (2) Wire Ties, secure the Control Module Assembly to left side of the Factory Harness as shown.
C. Using two (2) Wire Ties, secure the Remote Start Harness to the Factory Harness as shown.
D. Trim excess Wire Tie material.
Ensure the Control Module Assembly is fully seated on the left of Factory Harness.
Ensure the Control Module Assembly does not interfere with the Steering Column Shaft.
N
O
T
E
Wire Tie Mounting Holes
Feed wire tie through each
hole on Control Module and
tie to vehicle harness.
Control Module
Assembly
Grommet on
Bulkhead
Wire Ties
Factory
Harness
Black 6-Pin
Antenna
Connectors
Black 4-Pin
Connector
Black 20-Pin
Connector
Antenna
Control Module
Antenna
Bracket
MDPS
OBDII Connector
Fuse Box
Remote Start
Harness Fuse
Wire Ties
Revision Date
01/02/2019
Page 6 of 10
