E) To use hot water, turn the burner ignition knob to position 2 (Fig. A) and select the required
temperature with the thermostat control (Fig. B).
Note:
- In position 1, the burner is off and only cold water is delivered.
- In position 2, the burner is on and hot water is delivered at the temperature set by the
thermostat control knob (Fig. B page 4).
2) USE:
The machine can intake and mix detergents or other liquid chemicals (not corrosive) thanks to
an automatic device. Adjust amount of detergent to be mixed with the water delivered from the
spray gun by turning the detergent regulation knob (Fig. C).
We suggest using the detergent in the following way:
- apply the detergent on the surface to be cleaned
- stop spraying and wait 3-4 minutes
- start the hot jet of water
To avoid chemical deposits building up, we suggest cleaning the machine by sucking up clean
water for a few seconds.
Always clean small areas at a time because if the detergent gets dry, it could damage the
painted surfaces.
3) STOP:
When you have finished using the machine, act as follows:
A) Shut off the gun.
B) Turn the knob (Fig. A) to 1 (burner OFF)
C) Open the gun and spray the water out for about one minute
(until the temperature comes down and cold water comes out).
D) Turn the knob (Fig. A) to OFF/0 position.
E) Turn off the water tap.
F) Open the spray gun for a few seconds to release water and pressure trapped in the hoses
G) When you have finished using the machine, disconnect the power supply and water mains
and keep the machine in a closed room.
CAUTION:
make sure that water is cold before stopping the machine.
Page 10
Summary of Contents for HYW10200
