Page 18
7.4.3.
Slide the engine toward the front of plate and slip the old V-belt(s) off of the
wheel pulley and install the new V-belt(s) in their place.
7.4.4.
Position the V-belt(s) over the engine pulley.
7.4.5.
Move the engine back.
When adjusting the belt(s), make sure that the clutch pulley is in alignment with
exciter pulley.
7.4.6.
When the V-belt tension is correct, tighten the jam nuts B and the engine
mount bolts.
7.4.7.
Replace the belt guard.
7.5.
Exciter lubrication.
The exciter housing is pre-serviced using Automatic Transmission Fluid Dextron III, Mercon,
EXXON (ESSO) NUTO H-32 or its equivalent. Change fluid after 200 hours of operation.
7.5.1.
Let exciter cool before changing exciter oil.
7.5.2.
Remove the belt guard and V-belt(s). Remove the bolts that hold the deck to
the housing. Lift entire deck with engine from housing.
7.5.3.
Remove pipe plug from top of exciter housing Tilt housing upside down so oil
drains from exciter. Examine oil for metal chips as a precaution to future
problems.
7.5.4.
Return plate housing to the upright position.
Summary of Contents for HYCP5030
Page 1: ...User Manual ...