![background image](http://html.mh-extra.com/html/hyundai/hycp5030/hycp5030_user-manual_2197164016.webp)
Page 16
10.
MAINTENANCE
Before carrying out any maintenance the engine MUST be turned off
and allowed to cool.
7.1.
Preventative maintenance.
Maintaining your compactor make sure the machine and its components have a longer
working life.
7.1.1.
Keep the engine’s throttle lever in its SLOW position, and remove spark plug
lead from spark plug and secure.
7.1.2.
Inspect the general condition of the plate compactor. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts, and any
other condition that may affect its safe operation.
7.1.3.
Remove all debris from the plate compactor with a soft brush, vacuum, or
compressed air. Then use a premium quality lightweight machine oil to
lubricate all moving parts.
7.1.4.
Clean the bottom of the compactor base as soon as it begins to pick up soil
being compacted. The unit cannot do a good job if the bottom surface is not
smooth and clean.
7.1.5.
Replace the spark plug lead.
Never use a “pressure washer” to clean your plate compactor. Water
can penetrate tight areas of the unit and cause damage to spindles, pulleys,
bearings, or the engine. The use of pressure washers will result in shortened life and reduce
serviceability.
7.2.
Checking the V-Belt/s.
When removing or installing the drive belt(s), be careful not to get
your fingers caught between the belt and pulley.
On new machines or after installing a new belt, check belt tension
after first 20 hours of operation. Check and adjust belt every 50 hours thereafter.
To ensure optimum power transmission from the engine to the eccentric shaft, the V-
belt(s) must be in good condition and operate under proper tension.
7.2.1.
Remove the belt guard to access the V-belt(s).
7.2.2.
Check the condition of the V-belt(s). If any V-belt is cracked, frayed, or glazed,
it should be replaced as soon as convenient.
7.2.3.
Check the V-belt tension by squeezing them in the centre. The normal
deflection on each side should be 9mm (3/8”) to 13mm (1/2”) with moderate
pressure from your thumb or finger.
Summary of Contents for HYCP5030
Page 1: ...User Manual ...