Hyundai HYCH1500E-2, User Manual, Page: 7 / 44

7
1.70 Noise (where applicable).
1.71 The operating noise of the machine can damage your hearing. Wear hearing
protection such as earplugs or ear defenders to protect your hearing. Long- term and
regular users are advised to have hearing checked regularly. Be especially vigilant
and cautious when wearing hearing protection because your ability to hear alarm
warnings will be reduced.
1.72 Noise emissions for this equipment is unavoidable. Carry out noisy work at approved
times and for certain periods. Limit the working time to a minimum. For your personal
protection and protection of people working nearby it is also advisable for them to
wear hearing protection.
1.73 See CERTIFICATE of CONFORMITY section for Outdoor Noise declaration of
conformity.
1.80
Machine specific safety.
1.81 Working with the chipper - The chipper is designed solely for chipping all kinds of
newly cut tree branches of diameters up to 100 mm for HYCH1500E-2 or 70mm for
HYCH7070[E]-2
1.90
Usage restrictions.
1.91 You should NOT use the chipper for chipping metal, stones, and plastics and other
hard materials that may damage your machine. If you are going to chip tree roots
check that the diameter is less than 70 / 100mm and remove all earth, sand, stones
etc.
1.92 After the first hour’s use check that the bolts of the blades and counter blade are firm
ly fixed and that the gap between blades and counter blade is 1 - 2mm adjust as
required.
1.A
Description of machine
- This chipper is a machine for chipping newly cut wood.
1.A1 The rotor has 2 blades each with a 300 mm width and is powered by a petrol engine.
Transmission is through two parallel drive belts. The chips of wood are discharged
through the discharge chute by the centrifugal force of the rotor. Because of the angle
of the blades and the positioning of the counter blade branches are pulled inside the
machine automatically. Side branches greater than 30mm should be sawn off before
loading into machine.