If the mixture has not been fully mixed there is a danger of the piston jamming
due to insufficient oil.
4.5.
Fueling the machine.
4.5.1.
Untwist and remove the fuel cap, make sure that the fuel tank inlet is kept
free of any debris and DO NOT allow any debris to enter the fuel tank.
4.5.2.
DO NOT overfill – fill to approximately 80% of normal full capacity to allow
for expansion.
4.5.3.
Replace the fuel cap and make sure it is fully tightened. DO NOT use the
machine without having the fuel cap fitted.
4.5.4.
Fuel mixture which has not been used for over a month or more will clog the
carburetor causing the engine to operate incorrectly. DO NOT dispose of used
fuel down a drain or allow it to drain into a water course. YOU MUST dispose of
unused fuel at an authorised recycling point.
5. OPERATION
5.1.
Starting the engine.
The cutting head will start to rotate when the engine starts.
5.2.
Rest the unit on a flat firm surface. Keep the cutting head off the ground and clear
of surrounding objects.
5.3.
Push the primer bulb (1) until fuel flows out of the clear tube.
OP1.
5.4.
Move the choke lever (1) to the closed position (2). OP2.
5.5.
Set the ignition switch (4) to the start position (5). While
pulling the throttle lever (7), push the throttle set button and
release the throttle. The throttle is now in the start positon.
(OP3).
Page 10