4
Basic steps to install
1. Connect the output plug of the mains adapter to the adapter socket on
the back of the base unit and the mains adapter to the wall mains supply.
2. Connect the telephone lead to the phone cord socket on the back of the
base unit and to the wall phone socket.
4.3.
Remove the battery door on the handset by pressing the catch between
the charging connectors and lift.
4. Insert 2 x AAA rechargeable batteries, observing their polarities, into the
battery compartment.
5. Replace the battery door firmly into place.
6. Place the handset on the base unit and let the batteries charge for a full
14 hours before using.
Use only the mains adapter supplied with this telephone. Incorrect adapter
polarity or voltage can seriously damage the unit.
Input: 230 VAC 50 Hz
Output: 6VDC 400 mA
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. Refer to the original type supplied with this telephone. NiMH
batteries must be disposed of in accordance with applicable waste disposal
regulations.
Charging the handset
An empty battery icon indicates the batteries need recharging. Place the
handset on the base cradle to recharge the batteries. You should hear a
parking tone (double beep) when handset is put on the charging cradle. The
handset battery icon
scrolls during charging. Handset may take some time
to power up and it may get warm during initial charge. This is normal. A
handset reaching a very low battery voltage level will go into sleep mode,
displaying
LOW BATT
on the screen.
Get into the habit of putting the handset on the base unit to charge when it is
not in use to ensure the handset is always fully charged.
BASIC OPERATIONS
During standby
When the phone is in standby, the LCD displays the handset label. The
handset number related to the connected base will also be displayed right
justified. The battery icon reflects the current battery level and the signal
icon indicates the handset is linked to the base.
Answering an incoming external call
When there is an incoming call, the phone rings and
flashes. If a CID
record is received, the caller information is displayed.
turns on if the phone number contains more than 12 digits. In this case,
only the last 12 digits are displayed.
If you press when the phone is ringing, the handset ringer will be
turned off for this incoming call.
1. Press to answer the call.
turns on.
2. Call timer is displayed 10 seconds after the call is connected
3. Press or place the handset on the base cradle to disconnect.
Making an external call
Your phone allows you to dial out a phone number in various ways.
Normal dialing
1. Press and wait for the dial tone.
2. Use the number pad to dial the phone number. The display shows the
digits as you enter them.
3. When you enter more than 12 digits, turns on. In this case, you only
see the last 12 digits on the screen.
HDT-L3
1
JOHN DOE
BASIC OPERATIONS
