![background image](http://html1.mh-extra.com/html/hyundai/hdbt32/hdbt32_original-instructions-manual_2195659004.webp)
4
Envelop the blade before storage. Keep children away from it.
Never remove the machine’s guard.
Do not store in a closed area where fuel vapors can reach an open flame from hot water heaters,
furnaces, etc. Store in a locked, well-ventilated area only.
Never place the machine in any places where there are flammable materials (dry grass, etc.),
combustible gasses or combustible liquids.
When the machine is placed in storage for a long time, drain fuel from the fuel tank and
carburetor, clean the parts, move the machine to a safe place and confirm that the engine is
cooled down.
emission of exhaust gases
National regulation can restrict the use of the machine.
Never modify a trimmer or cutter in any way.
Improper use of the machine can cause SERIOUS OR FATAL PERSONAL INJURY.
The engine exhaust form this product contains chemicals to cause cancer, birth
defects, of other reproductive harm.
Kickback and Related Warnings
● Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other
accessory. Pinching or snagging causes rapid stalling of the rotating accessory which in turn causes the
uncontrolled power tool to be forced in the direction opposite of the accessory’s rotation at the point of the
binding.
● For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel that
is entering into the pinch point can dig into the surface of the material causing the wheel to climb out or
kick out. The wheel may either jump toward or away from the operator, depending on direction of the
wheel’s movement at the point of pinching. Abrasive wheels may also break under these conditions.
● Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can
be avoided by taking proper precautions as given below.
a) Never place your hand near the rotating accessory.
Accessory may kickback over your hand.
b) Do not position your body in the area where power tool will move if kickback occurs.
Kickback
will propel the tool in direction opposite to the wheel’s movement at the point of snagging.
c) Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the
accessory.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and
cause loss of control or kickback.
OPERATION OF QUICK RELEASE MECHANISM
Pull the strip to release the machine from you in the case of emergency.
Summary of Contents for HDBT32
Page 27: ...25...