![background image](http://html1.mh-extra.com/html/hyundai/hdbt32/hdbt32_original-instructions-manual_2195659006.webp)
6
2. YOUR PRODUCT
a. Description
1. BLADE 3Z blade for grass, weed or brush cutting applications. Harness and plastic shield are
required for blade operation
2. NYLON CUTTER HEAD Contains replaceable nylon trimming line that advances when the
trimmer head is tapped against the ground while the head is turning at normal operating
speed.
3. CUT-OFF KNIFE Trims nylon filament to the correct length-W , head to end of line-when
nylon trimming head is bumped on the ground during operation, line advance. If trimmer is
operated without a cut-off knife the line becomes too long (more thanW ) the engine, this will
overheat or damage the engine.
4. DEBRIS SHIELD Mounted just above the cutting attachment. Helps protest operator by
deflecting debris produced during debris produced during the trimming operation. Do not
operate unit without shield.
5. HANDLE this handle can be adjusted at you convenience for comfort.
6. DRIVE SHAFT ASSEMBLY Contains a specially designed liner
hard
drive shaft.
W. IGNITION SWITCH “slide switch mounted on top of the Throttle Trigger Housing. Move
switch FORWARD to
STOP
, BACK TO
Run
.
8. SAFETY LEVER Before acceleration, compress it please.
9. THROTTLE TRIGGER Spring loaded to return to idle when released. When accelerating,
press trigger gradually for best operating technique. Do not hold trigger while starting.
10. PURGE BULB Pushing purge bulb (W to 10 times before starting),will remove all air and sale
fuel from fuel system and bring fresh fuel to the carburetor.
11. FUEL TANK LID.
12. FUEL TANK Contains fuel and fuel filter.
13. AIR CLEANER COVER Contains replaceable felt element.
14. CHOKE the choke control is located on the top of the filter cover.
15. STARTER HANDLE pull handle until engine starts, then return handle slowly. DO NOT let
handle snap back or damage to starter will occur.
Summary of Contents for HDBT32
Page 27: ...25...